Search found 5 matches

by Vintageconn
Thu Mar 25, 2021 8:09 pm
Forum: Wahoo™ Support
Topic: Software improvement suggestions
Replies: 114
Views: 2044892

Re: Software improvement suggestions

I read some previous posts that touched on MIDI Sync, this suggestion may be a little different, and is hopefully not difficult to implement. With firmware 1.5.00 an LFO set to MIDI Sync responds to MIDI Start, Stop & Continue commands, and apparently requires Start or Continue to begin cycling ...
by Vintageconn
Tue Mar 23, 2021 5:25 am
Forum: Wahoo™ Support
Topic: LFO MIDI Sync not working
Replies: 1
Views: 6803

Re: LFO MIDI Sync not working - figured it out

I figured it out - the Wahoo needs to see a MIDI Start (FA) or Continue (FB) command before it will respond to MIDI Clock. I have a MIDI Clock source in my effects rack that responds to tapping a Boss FS-5U foot switch, the clock source doesn't send Start or Continue. I'll have to figure out a way t...
by Vintageconn
Sun Mar 14, 2021 3:11 am
Forum: Wahoo™ Support
Topic: LFO MIDI Sync not working
Replies: 1
Views: 6803

LFO MIDI Sync not working

I haven't been able to get MIDI Sync to work. Desktop & firmware: 1.5.00, hardware: 1.0.00 I have F1 in LFO mode. The filter sweeps when I use Tempo or Pedal mode - I can hear it, and I can see it using the Wahoo editor. (It's hard to tell if Tap Tempo is working.) I've tried 2 ways to implement...
by Vintageconn
Sat Mar 31, 2012 5:53 am
Forum: G2M™ Support
Topic: Rackmount G2M
Replies: 1
Views: 5360

Rackmount G2M

I see suggestions for putting a G2M in a pedalboard. Have you considered a rack mount version, with any control or switches on the panel face? It would easily fit in a 1/2 width 1U slot. I'm considering mounting my G2M inside my effects case. Is there an amperage limit I should observe for a 9V DC p...
by Vintageconn
Sat Mar 31, 2012 5:39 am
Forum: G2M™ Support
Topic: G2M/B2M with Sax live
Replies: 12
Views: 33391

Re: G2M/B2M with Sax live

I use a G2M with a tenor sax live. I use a noise gate, but I mainly rely on an expression pedal that control the mix of the G2M midi + plain sax audio signal. When the pedal is backed off there is no output from the synthesizer being mixed into my horn sound. I'm always playing loud enough that I do...