Mapping Dry/Wet tot Expression Pedal

For the Wahoo™ Dual-Analogue, Digitally-Controlled Wah/Filter Pedal

Moderators: johnmc, james

Mapping Dry/Wet tot Expression Pedal

Postby actitect » Tue May 05, 2020 5:04 pm

Hello everyone,

I recently bought the Wahoo and use it mainly with synthesizers.
Although I instantly notice the device is primarily created for guitarists, the hardware and concept is great and should also be perfect for synths.

But for synth-purpose I miss some things. The most important thing I would like to be able to do is map one or both filter Dry/Wet values to the expression pedal. With the software I was able to create a custom patch witch kinda mimics the result of a dry wet expression, but it was far from perfect.
Just a simple direct mapping of the Dry/Wet 0-100 to the Expressions Pedal HeelDown-ToeUp would already be very useful.

Is there a way to achieve this? Or would it be something technically possible to create in a firmware update or mod?

Thank you all very much for your consideration and reply.
Posts: 0
Joined: Tue May 05, 2020 4:51 pm

Re: Mapping Dry/Wet tot Expression Pedal

Postby james » Mon May 11, 2020 8:22 am

Technically, this is possible, but the results wouldn't be smooth. The wet/dry mix is controlled by a digital pot, so it has steps as it switches between values. If you swept the wet/dry mix you would hear zipper noise as it did this. If you play something and adjust the wet/dry you might be able to hear this. Usually it's quite subtle, but we'd want it to be perfect before allowing it to be modulated (like the filter sweep etc).
User avatar
Site Admin
Posts: 1861
Joined: Fri Jun 06, 2008 8:12 pm

Return to Wahoo™ Support

Who is online

Users browsing this forum: No registered users and 2 guests