problem with heel-down position

For the Wahoo™ Dual-Analogue, Digitally-Controlled Wah/Filter Pedal

Moderators: johnmc, james

Post Reply
rm999
Posts: 1
Joined: Sun Feb 18, 2018 5:45 am

problem with heel-down position

Post by rm999 »

Hello,

My Wahoo seems to have some trouble with heel-down position. Even though I set the pedal to the heel-down position, my Wahoo seems to recognize that the pedal is still halfway. I found this problem while I was doing these things:

1. connecting Wahoo to Desktop Editor
Desktop Editor showed that Wahoo is not in 100% heel-down position though the pedal is completely in heel-down position physically.

2. monitoring MIDI CC value
The value of CC#11 was changed only from 22 to 127; I think this should show 0 to 127 if everything is OK.

I found this topic and tried the calibration mode, too.
viewtopic.php?f=22&t=1126
The calibration mode showed 330-493 whereas it is mentioned in the topic that this should be approximately from 280 to 490.
The firmware is up-to-date. (1.5.00)

Do you guys have any idea to fix this problem? Is there any setting I have missed?
User avatar
james
Site Admin
Posts: 1866
Joined: Fri Jun 06, 2008 8:12 pm

Re: problem with heel-down position

Post by james »

The numbers shown for calibration look ok. 330-493 is within normal values.

Calibration should fix this, and the offset on the MIDI data (22 instead of 0) seems very large. When you did the calibration did you press SAVE to make sure the calibration was saved? Maybe you can try the calibration procedure again to check this.
Post Reply