voluum - power
voluum - power
is it possible to power up a voluum pedal with voodoo lab mondo? Thank you
Re: voluum - power
We haven't tried this, but it should be possible.
From what I can tell, the Mondo has "high-current" outputs rated at 400mA. The Voluum is rated a 500mA. However, if you don't set the Voluum's LEDs to maximum brightness, 400mA should be fine - by default the LEDs are set to 40%.
From what I can tell, the Mondo has "high-current" outputs rated at 400mA. The Voluum is rated a 500mA. However, if you don't set the Voluum's LEDs to maximum brightness, 400mA should be fine - by default the LEDs are set to 40%.
Re: voluum - power
hi cchisaac
I use my voluum and wahoo both powered of a pedal power mondo so yes it does work fine, as per james's suggestion i did lower the led brightness a tad just to be on the safe side, hope this helps. because my board is full i have actually powered mine of the 12v sections from the 12v ports in the past, i longer need to do this however there is an old thread on it to be found here
viewtopic.php?f=28&t=1384&p=3890#p3890
I use my voluum and wahoo both powered of a pedal power mondo so yes it does work fine, as per james's suggestion i did lower the led brightness a tad just to be on the safe side, hope this helps. because my board is full i have actually powered mine of the 12v sections from the 12v ports in the past, i longer need to do this however there is an old thread on it to be found here
viewtopic.php?f=28&t=1384&p=3890#p3890