Updating functons

For the Wahoo™ Dual-Analogue, Digitally-Controlled Wah/Filter Pedal

Moderators: johnmc, james

Post Reply
Tex
Posts: 0
Joined: Sat May 30, 2020 8:32 pm

Updating functons

Post by Tex »

Hi,
I've had my pedal from new but it was so long ago I can't remember when I bought it. Is it possible to update it so it can be switched on and off without using the footswitch? I've noticed the current user manual shows this as an option in the custom sub-parameters P.En settings. My knowledge of tech is very limited. I would love to put it back on my pedal board.
Pedal serial number: 4001035.
User avatar
james
Site Admin
Posts: 1866
Joined: Fri Jun 06, 2008 8:12 pm

Re: Updating functons

Post by james »

Yes, you can do this. "P.En" was added in firmware version 1.1.0. (1.3.0 is the latest version).

This allows the Wahoo to turn on when the footpedal is moved to the toe-down position (or you can invert it so it turns on in the heel-down position instead). There is also an "off time" which lets you configure how long the pedal needs to be in the off position before the Wahoo turns off. This prevents the effect being turned off by mistake in normal use.

You can check which firmware your Wahoo has by holding the "SAVE" button while you turn on the Wahoo -- the display will show the version number.
Post Reply