Treadle is loosening
Treadle is loosening
The treadle of my Wahoo is getting a bit loose. Well, as far as I can see it's not the joint of the treadle itself, but the two screws that attach the treadle and its joint to the enclosure. Haven't come around of opening it up yet, cause it's the end of the semester (yeea, I'm procrastinating right now) and I'm not sure if that'll void my warranty (btw, will it?). When opened up, are those two screws easily reachable or will I have to unscrew the platine as well?
Re: Treadle is loosening
It is easy to access the two screws. It won't void your warranty.
Please see the attachment. It describes how to completely remove the pedal. You don't need to do this, you only need to tighten the two nuts on each bolt (see section 3 at the end of the document for more details). Two nuts are used to lock everything in place. These must not have been correctly tightened and that's why they have come loose.
Please see the attachment. It describes how to completely remove the pedal. You don't need to do this, you only need to tighten the two nuts on each bolt (see section 3 at the end of the document for more details). Two nuts are used to lock everything in place. These must not have been correctly tightened and that's why they have come loose.
- Attachments
-
- Wahoo_Pedal_Tension_Guide.pdf
- (4.56 MiB) Downloaded 664 times
Re: Treadle is loosening
Thanks for the quick answer and the helpful PDF. Your customer support kicks butt
Re: Treadle is loosening
I have the same problem and tried to follow the attached instructions. However 2 of the screws on the back panel won't budge and the heads are stripping so I can't get the back panel off. Help please?
Re: Treadle is loosening
Normally the screws should be tight enough for the head to be stripped. However, if this happens, it's easy to get the screw off with a drill: use a 3mm drill and gently (slowly) drill the screw head. Once you drill far enough the outside of the screw head will fall off and the base panel can then be removed. What's left of the screw can then be removed using pliars to unscrew it. If done carefully, you won't cause any damage to the base plate (the drill won't touch it).
Re: Treadle is loosening
Fixed. Had to strip heads off 3 screws and there was not enough thread sticking out/too tight to remove, so left them in. Still, seems ok and still works.
Re: Treadle is loosening
Thanks for the update. I'm glad you got it working. I'm not sure why so many screws were hard to remove. I've only ever seen one screw like this, and I've opened quite a few Wahoos.