Can anyone help me with latency.
i pyt b2m thru alesis io2 audio/midi inteface. i usecubase software. latency is unacceptable.
midi cable is pretty long (can that affect latency?)
what should i do, what setting to use to minimise latency
thx
M
Latency in B2m
Re: Latency in B2m
Cable length won't affect the latency. It is most likely your audio settings. Check out this FAQ to see if it helps:
viewtopic.php?f=11&t=14
viewtopic.php?f=11&t=14
-
StickPlayer
- Posts: 10
- Joined: Thu May 13, 2010 11:01 pm
Re: Latency in B2m
The latency you are experiencing is not coming from the B2M - at least not the "unacceptable" amount.
You need to check and see what you have set up in Cubase or any software that supports your I/O.
I use RME interfaces that are near ZERO - but they are really somewhere near 6-10ms delay by the time everything is running. It's part of computer-based recording.
If you are going bass-to-B2M-to-I/O-to-Cubase-to-monitor, it's going to add up.
Depending on your ear, anything more than 10-12 ms can be hard to deal with.
Are you monitoring with headphones? Know that every foot you are away from a speaker adds about another millisecond of delay.
You need to check and see what you have set up in Cubase or any software that supports your I/O.
I use RME interfaces that are near ZERO - but they are really somewhere near 6-10ms delay by the time everything is running. It's part of computer-based recording.
If you are going bass-to-B2M-to-I/O-to-Cubase-to-monitor, it's going to add up.
Depending on your ear, anything more than 10-12 ms can be hard to deal with.
Are you monitoring with headphones? Know that every foot you are away from a speaker adds about another millisecond of delay.